Connecting to a Windows NT Server 4.0
Windows NT Workstation 4.0
adapter card into a PCI slot.
2
Connect network media to the 3COM 3C905 PCI card.
3
Insert a DOS bootable diskette and power on the machine.
4
After booting, insert the 3COM Etherlink 3C905 Ethernet card and drivers
Disk 1 ver 2.1. and execute “A:\3C90XCFG.EXE.”
5
Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
6
If changes are required, save those changes and exit.
7
Remove the 3Com card drivers diskette and reboot the machine.
8
Power on the machine and allow it to boot to Windows NT Workstation
4.0.
9
Log onto the machine with Administrator privileges. (If you do not have
the required information, contact your network administrator.)
10
Click on “Start” and move to “Settings”, open the “Control Panel” group,
and double-click the “Network” icon.
11
Click on the “Yes” button and agree to install “Windows NT Networking.”
12
With “Wired to the Network” checked, click on “Next.”
13
Click the option to “Select from list” then on “Have Disk.”
14
Insert the 3COM 3C905 drivers disk 1 into the floppy drive.
15
Change the path to “A:\” for the “Insert Disk” dialog and click “OK.” (If you
have a Hewlett-Packard preloaded HDD, set the path statement to
“C:\MASTERS\LANDRV\3C905\Disk1\”)
If you are using a Vectra VL8, go directly to 16.
If you are using a Vectra VL7, follow the instructions below and then go to
18.
•
1. Select "3Com Fast Etherlink XL Adapter (3C905 )" and click "OK."
•
2. With "3Com Fast Etherlink XL Adapter (3C905 )" listed in the "Net-
work Adapters" window, click on "Next."
16
Select “3Com Fast Etherlink/Etherlink XL PCI Busmaster NIC” and click
“OK.”
17
With “3Com Fast Etherlink/Etherlink XL PCI Busmaster NIC” listed in the
“Network Adapters” window, click on “Next.”
c905.bk : ch_12.fb4 Page 2 Thursday, October 22, 1998 9:51 AM
