Connecting to a Netware 4.1 server
Windows 95 SR2
Procedure
1
With the HP Vectra turned off, install the 3COM Etherlink III 3C905
adapter card into a PCI slot.
2
Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3
Insert the 3COM drivers diskette (ver. 2.1 downloaded from 3COM’s Web
site) and execute 3C90XCFG.EXE.
4
Select “CONFIGURE NIC” and verify the resource settings listed above
under the heading “Device Configuration.”
5
If changes are required, save those changes and exit.
6
Remove the 3Com cards driver diskette and restart the machine.
7
Windows 95 SR2 should automatically recognize the 3COM 3C905
Ethernet card.
8
With “PCI Ethernet Controller” listed, click on “Next.”
9
Click on “Other Locations” and insert the 3C905 driver’s disk 1 of 2.
10
Set the path to “A:\” and click on “OK.” (If you have a Hewlett-Packard
preloaded HDD, set the path statement to
“C:\MASTERS\LANDRV\3C905\Disk1\”)
11
“3Com Etherlink XL TPO 10Mb Ethernet Adapter” should now be listed.
Click on “Finish.”
12
When prompted, insert the 3C905 driver’s disk 2 of 2 and click on “OK.”
If you are using a Vectra VL8, go directly to step 13.
If you are using a Vectra VL7, follow the instructions below then go to step
15.
•
In the "Copying Files…" window, the path should read "A:\Win95\" (If
you have an HP pre-loaded HDD, set the path statement to "C:\MAS-
TERS\LANDRV\3C905\Disk2\Win95\")
•
Click on "OK" to continue the installation.
13
Insert the 3C905 driver’s disk 1 of 2.
14
Set the path to “A:\” and click on “OK.” (If you have a Hewlett-Packard
preloaded HDD, set the path statement to
“C:\MASTERS\LANDRV\3C905\Disk2\”)
15
Click on “OK” to provide Computer and Workgroup names.
c905.bk : ch_4.fb4 Page 2 Thursday, October 22, 1998 9:51 AM
