HP Vectra VL410, Deployment Manual

Page: 108 / 108

HP Toptools
HP Toptools Deployment Guide Version 5.5
108
11.2.1 Prerequisites
The utility is supported under Windows 95, 98, NT4 (SP3 or higher) and Windows 2000. It is only
supported on the following HP PC models:
HP Vectra VE 5/xxx Series 3
HP Vectra VE 5/xxx Series 4
HP Vectra VL 6/xxx Series 6
HP Vectra VL 6/xxx Series 7
HP Vectra VL 6/xxx Series 8
HP Vectra VLi Series 8
HP Vectra VL600
HP Vectra VL400
e-Vectra
HP Vectra VE C/xxx Series 7
HP Vectra VE 6/xxx Series 8
HP Vectra VEi Series 7
HP Vectra VEi Series 8
HP NetVectra 5/xxx
HP Kayak XA
HP Kayak XA series 05xx
HP Kayak XA-s series 02xx
HP Kayak XM600
HP Kayak XU
HP Kayak XU series 03xx
HP Kayak XU series 04xx
HP Kayak XU800
HP Kayak XW series A2, U2, W2
HP Kayak XW series U3, W3
HP Kayak XW series 04xx
HP Brio BA210
HP Brio BA410
The syntax of the command line is as follows:
WBIOSCFG.EXE /PARAMFILE=<Path to INI file> /LOGFILE=<path to log file>
The format of the INI file is as follows:
[Bios Settings]
Start from HDD enabled = <A boolean value YES or NO>
Start from Floppy enabled = <A boolean value YES or NO>
Start from CD enabled = <A boolean value YES or NO>
Start from Network enabled = <A boolean value YES or NO>
RPO on RWU enabled = <A boolean value YES or NO>
Floppy disk drive enabled = <A boolean value YES or NO>
Write on floppy enabled = <A boolean value YES or NO>
Serial port A enabled = <A boolean value YES or NO>
Serial port B enabled = <A boolean value YES or NO>
Parallel port enabled = <A boolean value YES or NO>
USB controller 1 enabled = <A boolean value YES or NO>
USB controller 2 enabled = <A boolean value YES or NO>
PnP OS = <A boolean value YES or NO>
Identification string = <A string value>
Admin Password = <One word>
User Password = <One word>
New Admin Password = <One word>
New User Password = <One word>
Note: if you use the same asset file on each PC, you will get homogeneous BIOS settings across your
installed base of PCs.