3.
Align the feet with their holes and press them in securely.
Figure 1-6
Installing the rubber feet
Installing the Stand
If you wish to use the thin client in a vertical orientation, you should install the stand for stability.
To install the stand:
1.
Turn unit upside down.
2.
Locate the slots on the bottom of the unit into which the tabs on the stand fit. Position the stand
with the wide part toward the front of the unit. Align the tabs on the widest part of the stand with
the slots approximately 7.6 cm (3 inches) from the front of the unit and the tabs on the narrower
part with the slots approximately 3.8 cm (1.5 inches) from the rear of the unit.
3.
Insert the tabs into the slots
(1)
and slide the stand toward the back of the unit
(2)
until it locks into
place.
Figure 1-7
Installing the stand
Product features
5
Summary of Contents for vc4820T - Thin Client
