Setup Utility—Power Management Setup
Table 3-6
Setup Utility—Power Management Setup
Option
Description
PWRON After PWR-
Fail
When power is lost and comes back, the option determines what power state the system should go
to. Options are Off, On, and Former-Sts. Default is Former-Sts.
Wake on PME
Enable/disable system wakeup capability for OnBoard LAN device and PCI card. Default is enabled.
BIOS Wake up
Enable RTC alarm wakeup. Default is disabled.
Day of Week
Select the alarm RTC wakeup day of Sunday through Saturday.
Time of Day
Select the alarm RTC wakeup time of day (hh:mm).
Setup Utility—Utility Task Actions
Table 3-7
Setup (F10) Utility Task Actions
Heading
Table
Load Factory Defaults
Select Yes or No (
Y
/
N
)
Set Administrator Password
Allows you to set, change, and disable the administrator password.
Set User Password
Allows you to set, change, and disable the user password.
NOTE:
When the user password is set, it prevents unauthorized access to the user's
setup. User password provides read-only access to Setup options.
Save & Exit Setup
Saves data to CMOS, then exit the Setup Utility.
Exit without Saving
Exit the Setup Utility without saving any changes.
Using the BIOS Settings
29
Summary of Contents for vc4820T - Thin Client
