HP V192B.BHP, Manual

Page: 10 / 24

10
ASSEMBLING AND PREPARING
Mounting on a wall
For proper ventilation, allow a clearance of 10 cm
on each side and from the wall.
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1 If you use screw longer than standard, the moni-
tor might be damaged internally.
2 If you use improper screw, the product might be
damaged and drop from mounted position.
In this case,
HP
Electronics is not responsible
for it.
10 cm
10 cm
10 cm
10 cm
y y
Disconnect the power cord first, and then
move or install the Monitor set. Otherwise
electric shock may occur.
y y
If you install the Monitor set on a ceiling or
slanted wall, it may fall and result in severe
injury.
y y
It is important to verify that the manufacturer’s
mounting solution is compliant with the VESA
standard and is rated to support the weight of
the display head.
y y
Do not over tighten the screws as this may
cause damage to the Monitor set and void
your warranty.
y y
Use only screws and wall mounts that
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
y y
Screw length from outer surface of back
cover should be under 8mm.
y y
Use the screws that are listed on the VESA
standard screw specifications.
y y
The wall mount kit will include an installation
manual and necessary parts.
y y
The wall mount bracket is optional. You can
obtain additional accessories from your local
dealer.
y y
The length of screws may differ depending
on the wall mount. Be sure to use the proper
length.
y y
For more information, refer to the
instructions supplied with the wall mount.
CAUTION
NOTE
Back Cover
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
Max.8mm
Wall Mount
(A x B)
100 x 100
Standard
screw
M4
Number of
screws
4