Display assembly
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
Keyboard/top cover on page 22
).
Remove the display assembly:
1.
Release the ZIF connector (1) to which the display panel cable is attached, and then disconnect the
display panel cable from the system board.
2.
Disconnect the wireless antenna cables (2) from the WLAN module terminals.
NOTE:
The #1/white WLAN antenna cable connects to the WLAN module Main terminal. The #2/black
WLAN antenna cable connects to the WLAN module Aux terminal.
3.
Release the wireless antenna cables from the retention clips (3) built into the base enclosure.
4.
Remove the four Phillips PM2.4×4.7 screws (4) that secure the display assembly to the base enclosure.
5.
Remove the display assembly (5).
6.
If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Remove the two display bezel screw covers (1).
NOTE:
The display bezel screw covers are included in the Rubber Kit, spare part number
800747-001.
38
Chapter 5 Removal and replacement procedures
Summary of Contents for Stream 11 Pro
Page 4: ...iv Safety warning notice ...
Page 7: ...Index 61 vii ...
Page 8: ...viii ...
Page 19: ...Bottom Item Component Description 1 Speakers 2 Produce sound Bottom 11 ...
