Removal and replacement procedures 30
Hot-plug I/O module
To remove the component:
1.
Be sure the hard drive drawer is closed all the way.
2.
Disconnect the SAS cables.
3.
Release the I/O handle.
4.
Push the I/O handle down until it ejects the I/O module.
5.
Remove the I/O module.
CAUTION:
For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component, replace it
with a blank.
To replace the component, reverse the removal procedure. Be sure the I/O module is fully seated and the
I/O module handle is in the locked position.
Power supply
To remove the component:
1.
Power down the MDS600 ("
Power down
" on page
24
).
2.
Disconnect the AC power cord.
Summary of Contents for StorageWorks 600 All-in-One
