System Board
CAUTION:
Be very careful when removing or replacing the system board to prevent damaging it.
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 92
).
2.
Remove the computer access panel (
Computer Access Panel on page 99
).
3.
Remove the optical drive (
Removing the Existing Optical Drive on page 107
).
4.
Remove the memory modules (
Installing Additional Memory on page 102
).
5.
Remove the front fan (
Front Fan on page 116
).
6.
Remove the hard drive (
Hard Drive on page 110
).
7.
Remove the hard drive cage (
Hard Drive Cage on page 114
).
8.
Remove the front I/O panel cage:
a.
Remove the screw from the right side of the cage that secures the I/O panel cage to the front
of the chassis
(1)
.
b.
Press the tab on right side of the cage
(2)
, and then swing the right side of the cage away
from the chassis to remove it
(3)
.
NOTE:
If the cage sticks and will not come loose, press down on the top of the panel near
the tab while pressing the tab.
Figure 7-35
Removing the I/O panel cage
9.
Remove the heat sink (
Heat sink on page 119
).
10.
Disconnect all cables connected to the system board, noting their location for reinstallation.
System Board
123
Summary of Contents for SignagePlayer mp8000r
