Hewlett Packard
SCSI-Fibre Channel Router Installation and User Guide
Revision 1.0.2
Page 3
2.3. Step Three: Clear the Node Mapping Table of the Host Router
For further information on clearing the Node Mapping Table, see section 3.2.5.
1. Ensure power is off to the host router and it is not connected to the device router.
2. On the host router, set DIP switches 4 and 5 in the down position on switch 2 (SW2) to
clear the Node Mapping Table.
3. Power on the host router.
•
The power LED (green) is solid on. If the power LED is off then see section 4.3
Power LED Not Lit.
4. When the Fault LED (yellow) is solid on and the Status LED (green) is blinking, it indicates
that the Node Mapping Table is cleared.
•
To locate the Fault LED, see Figure 3-1 and Figure 3-2.
Note: When the Node Mapping Table has been cleared the Status LED (green) blinks a
status code of 060 as described in Table B-1. Diagnostic Status Codes for Fault LED. To
decipher the LED read-out, see section 3.1.4 Presentation of Digital Numbers.
5. The process will take approximately 10 seconds.
6. Power off the host router.
2.4. Step Four: Setup Host Router
1. Ensure that the host router is powered off.
2. On the host router set all DIP switches on switch one (SW1) to the down position.
•
To locate switch one (SW1), see Figure 3-2.
3. Attach the host router to the device router with the appropriate copper or fiber optic cable.
Ensure that cable and connectors are securely fastened.
•
To ensure proper cable specifications, see section 4.1.3.
4. At this point the host/server should not be attached as shown below in Figure 2-2.
Figure 2-2. Example of Step Four Completed
2.5. Step Five: Run Connection Check
1. Power on the SCSI device(s). If disk drives then allow spin up time to complete
(maximum 2 minutes).
2. Power on the device router.
•
The power LED (green) is solid on. If the power LED is off then see section 4.3
Power LED Not Lit.
3. On the host router, set DIP switch 4 in the down position on switch 2 (SW2) to activate
the Connection Check mode.
•
This will check the Fibre Channel connection between the two routers.
4. Power on the host router.
•
The power LED (green) is solid on. If the power LED is off then see section 4.3
Power LED Not Lit.
5. The testing process will take approximately 1 minute. When the test has completed the
status LED and the fault LED will display one of two possible formats.
Host Router
Device Router
Attached SCSI Device
Fibre Channel
JBOD
SCSI cable
optic or
copper cable
