Hewlett Packard
SCSI-Fibre Channel Router Installation and User Guide
Revision 1.0.3
Page 15
Figure 4-7. SCSI Map
4.5.3.4. ‘R’: Force Hardware Reset
This command will reset only the local SCSI-FC Router. This is recommended when
lockup occurs.
1. To reset the local SCSI-FC Router, enter the capitol letter ‘R’. Do this only one time.
If entered successfully the screen will read the following below:
2. Check the local SCSI-FC Router’s fault LED. During reset, it will light.
3. After the reset has concluded and the screen reads ‘Ready .. … .’ then the user must
access the serial port by typing ‘hello’ again.
4.5.3.5. ‘C’: Clean Up Configuration Table
This function removes the old, unused configurations from the database.
1. To clean up the configuration table of the local router, enter the capitol letter ‘C’. Do
this only one time. If entered successfully the screen will read the following below:
2. After the reset has concluded and the screen reads ‘Ready .. … .’ then the user must
access the serial port by typing ‘hello’ again.
4.5.3.6. ‘H’: Download SCSI-FC Router Microcode
This function is used to update the microcode for the local router.
1. Ensure the SCSI-FC Router is in the host
mode.
2. Enter a capital letter
H
for host router.
3. Click on the open file icon
in the tool menu.
4. Browse the local computer to find and then select the microcode file that will be
downloaded to the local router.
5. Wait for download to complete to begin normal operations.
Warning: Do not download new microcode to the SCSI-FC if the
SCSI-FC is being utilized by the operating system. The SCSI-FC
will reset itself after the download is complete, which can cause
lost I/Os and system panic.
4.5.3.7. ‘D’: Download SCSI-FC Router Microcode
This function is used to update the microcode for the local router.
1. Disconnect the Fibre Channel from the device router.
2. Power off the device router.
3. Change the device router from the tape or disk mode to the host mode.
4. Power on the router.
5. Activate the PROCOMM Plus software (See section 4.5.2.3 Step Three: Start
PROCOMM PLUS).
6. Enter a capital letter D for device router.
7. Click on the open file icon
in the tool menu.
8. Browse the local computer to find and then select the microcode file that will be
downloaded to the local router.
9. After download is complete power off the router.
