Hewlett Packard
SCSI-Fibre Channel Router Installation and User Guide
Revision 1.0.2
Page 12
4.5.2.1. Step One: Install PROCOMM PLUS
Install the PROCOMM PLUS software in a proper computer. Hewlett-Packard
recommends installing PROCOMM on a laptop to provide mobility. Follow directions in
the PROCOMM PLUS installation guide for PROCOMM installation.
4.5.2.2. Step Two: Setup PROCOMM PLUS
1. Set Xmodem protocol.
2. Set modem baud rate to 57600.
3. Select ‘Incoming CR to CR/LF’ (see Figure 4-2).
4. Set ‘Tab stops every 4 positions’ (see Figure 4-2).
5. Connect the computer serial port to the SCSI-FC Router RJ-11 serial port.
Figure 4-2. Setup Information
4.5.2.3. Step Three: Start PROCOMM PLUS
Refer to the PROCOMM PLUS manual to activate the PROCOMM software.
1. After PROCOMM PLUS is activated, the PROCOMM PLUS for Windows Terminal will
appear (see Figure 4-3).
2. At the cursor, type hello and press enter.
Note: When typing hello, it will not be visible on the screen.
Figure 4-3. Startup Screen for Serial Port
