Operations 16
2.
Disconnect all peripheral cables from the server.
3.
4.
Place the server on a flat, level work surface.
IMPORTANT:
Both T-10 and T-15 screws are required for this procedure. When replacing the
component, be sure to install the screws in the proper location. Failure to do so will cause the
server to not install properly into the chassis.
5.
Using a T-10 Torx screwdriver, remove the PCI riser board assembly.
6.
Disconnect all cables connected to existing expansion boards.
Remove the drive cage assembly
1.
Back up all server data on the drive.
2.
Power down the server (on page
3.
Disconnect all peripheral cables from the server.
4.
5.
Place the server on a flat, level work surface.
6.
Summary of Contents for ProLiant XL230a Gen9
Page 71: ...Support and other resources 71 ...
