Hardware options installation 76
17.
Install the fan modules and the fan blank (on page
31
).
18.
Install any full-length PCI expansion cards that were removed ("
Installing an expansion board
" on page
63
).
19.
If a Smart Array controller is installed, connect the capacitor pack cable to it.
20.
Install the system air baffle (on page
28
).
21.
If removed, install the PCI air baffle ("
PCI air baffle option
" on page
38
).
22.
If necessary, remove the power supply blank.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
23.
Install one or two common slot power supply modules into the redundant power supply cage ("
Power
supply module
" on page
79
).
24.
Install the access panel (on page
26
).
25.
Return the server to an upright position.
26.
Lock the front bezel (on page
24
).
27.
Connect each power cord to the server.
28.
Connect each power cord to the power source.
29.
Power up the server (on page
23
).
Smart Array cable option
This cable option is required when installing a P430 Smart Array card.
To install the component:
1.
Power down the server (on page
23
).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the front bezel (on page
24
).
4.
Place the server on its side.