HP ProLiant ML30 Gen10 Plus, User Manual, Page: 143 / 230

Installing the iLO-M.2-serial module Installing the iLO-M.2-serial module
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION:
The port blank provides EMI shielding and helps maintain proper thermal status inside the server. Do not operate the
server when a port blank is removed without the corresponding I/O port option installed.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
Spudger or any small prying tool
Phillips No. 1 screwdriver
4.5 mm hex nut screwdriver
T-15 Torx screwdriver
Hex screwdriver—This tool is required for installing the serial port cable.
Procedure Procedure
Installing the iLO-M.2-serial module Installing the iLO-M.2-serial module
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel.
Installing the iLO-M.2-serial module 143