HP ProLiant DL380e Gen8, Maintenance And Service Manual

Page: 78 / 130

Removal and replacement procedures 78
Warning: The serial number should ONLY be modified by qualified service
personnel. This value should always match the serial number located on the
chassis.
5.
Press the Enter key to clear the warning.
6.
Enter the serial number and press the Enter key.
7.
Select Product ID . The following warning appears:
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
8.
Enter the product ID and press the Enter key.
9.
Press the Esc key to close the menu.
10.
Press the Esc key to exit RBSU.
11.
Press the F10 key to confirm exiting RBSU. The server automatically reboots.
Reactivate the HP Smart Array SAS license key
The boot order settings, firmware versions, and any additional HP software, including the HP Smart Array
SAS license key, are stored in the system board. Transfer this information to the new system board to ensure
normal server operation when the system board is replaced.
SAS license key reactivation is only required for the HP Dynamic Smart Array B320i Controller. SAS
functionality is automatically enabled in other HP Smart Array controller board options. To activate the SAS
license key, use HP Smart Storage Administrator.
You can access the HP SSA during POST or by using HP Intelligent Provisioning.
To launch HP SSA during POST:
1.
Boot the server.
During POST, the system recognizes devices.
2.
When the system recognizes a Smart Array controller, press F5 .
The system launches the HP SSA GUI, or if you are using Serial Console, the system launches the HP
SSA CLI.
To launch HP SSA using HP Intelligent Provisioning:
1.
Boot the server.
2.
Press F10 to launch HP Intelligent Provisioning.
3.
At the main screen, select Perform Maintenance .
4.
At the Maintenance screen, select HP Smart Storage Administrator (HP SSA) .
The system launches the HP SSA GUI.
To activate the HP Smart Array SAS license key:
1.
Launch the SSA GUI.
2.
Open the Configure panel by doing one of the following:
o
Choose a device and click Configure in the quick navigation menu.
o
Select an available device from the Home screen, and then click Configure under the available
options.
3.
In the Tools menu, click License Manager .