1.
Turn on or restart the computer, and then press the
esc
key or hold down the volume down
button while the “Hold the Volume Down button to enter the BIOS Startup Menu” is displayed at
the bottom of the screen. The Startup menu is displayed.
2.
Press
f10
to enter Computer Setup.
3.
Use a pointing device or the arrow keys to select System Configuration > Boot Options, then
follow the on-screen instructions.
4.
In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you
want the computer to display the startup location menu before it defaults to the current MultiBoot
setting. (When 0 is selected, the Express Boot startup location menu is not displayed.)
5.
To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of
the screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Main > Save Changes and Exit, and then follow the on-screen
instructions.
Your changes go into effect when the computer restarts.
Entering MultiBoot Express preferences
When the Express Boot menu is displayed during startup, you have the following choices:
●
To specify a boot device from the Express Boot menu, select your preference within the allotted
time, and then press
enter
.
●
To prevent the computer from defaulting to the current MultiBoot setting, press any key before
the allotted time expires. The computer will not start until you select a boot device and press
enter
.
●
To allow the computer to start according to the current MultiBoot settings, wait for the allotted
time to expire.
Using HP PC Hardware Diagnostics (UEFI)
HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine if the computer hardware is functioning properly. The tool runs outside
of the operating system to isolate hardware failures from issues that may be caused by the operating
system or other software components.
To start HP PC Hardware Diagnostics UEFI:
1.
Turn on or restart the computer, quickly press the
esc
, key or hold down the volume down button
while the “Hold the Volume Down button to enter the BIOS Startup Menu” is displayed at the
bottom of the screen. The Startup menu is displayed.
After pressing
f2
, the BIOS searches three places for the HP PC Hardware Diagnostics (UEFI)
tools in the following order:
70 Chapter 12 Computer Setup (BIOS), MultiBoot, and HP PC Hardware Diagnostics (UEFI)
Summary of Contents for Pro x2 612 G1
Page 1: ...User Guide ...
Page 4: ...iv Safety warning notice ...
