Removal and replacement procedures
4–12
3. Disconnect the hard drive cable
1
from the system board.
4. Grasp the Mylar tabs
2
on the hard drive and slide the hard drive
3
to the left.
5. Remove the hard drive from the hard drive bay
4
.
6. If it is necessary to replace the left and right hard drive brackets, Mylar sleeve, connector, and isolators:
a. Remove the two Phillips PM3.0×4.0 hard drive bracket screws
1
from each side of the hard drive.
b. Remove the left and right hard drive brackets
2
.
c. Lift the Mylar sleeve
3
straight up to remove it from the hard drive.
d. Remove the hard drive connector
4
.
e. Remove the four isolators
5
.
Reverse this procedure to reassemble and install the hard drive.
