Troubleshooting and Maintenance
51
Creating recovery discs
Complete the procedure described in this section to create a set of recovery discs from the
recovery image stored on your hard disk drive. This image contains the operating system and
software program files that were originally installed on your computer at the factory.
You can create only one set of recovery discs for your computer. Furthermore, the recovery
discs you create can be used only with your computer.
Choosing recovery discs
To create recovery discs, your computer must have a DVD writer.
Use DVD+R or DVD-R blank media to create your system recovery discs.
You cannot use CDs or DVD+RW, DVD-RW, DVD+RW DL, DVD-RW DL, DVD+R DL, or
DVD-R DL discs to create recovery discs.
Use high-quality discs to create your set of recovery discs. The verification standard for the
recovery disc creation process is very high. You may see error messages such as
Recording
failure when writing dis
c or
Error detected during disc verification
.
Your discs may be rejected if they are not defect-free. You will be prompted to insert a new
blank disc to try again. It is normal that some of your discs may be rejected.
The number of discs in the recovery disc set depends on your computer model (typically
1–3 DVD discs). The Recovery Disc Creator program tells you the specific number of blank
discs needed to make the set.
The process takes some time to verify that the information written on the disc is correct. You
can quit the process at any time. The next time you run the program, it resumes where it
left off.
To create recovery discs:
1
Close all open programs.
2
Click the
Start
button, click
All Programs
, click
Recovery Manager
, and then
click
Recovery Disc Creation
. If prompted, click
Yes
to allow the program to
continue.
3
Follow the onscreen instructions. Label each disc as you make it (for example,
Recovery 1, Recovery 2).
4
Store the recovery discs in a safe place.
System recovery options
You should attempt a system recovery in the following order:
1
Through the hard disk drive, from the Windows 7 Start menu.
2
Through the hard disk drive, by pressing the F11 key on the keyboard during system
startup.
3
Through recovery discs that you create.
4
Through recovery discs purchased from HP Support. To purchase recovery discs, go to
http://www.hp.com/support
and visit the Software & Driver downloads page for
your computer model.
Summary of Contents for P6210f - Pavilion - 6 GB RAM
