Command Line Interface 22
Accessing the CLI remotely
Remote administration of the switch occurs through the iLO/MGMT port, located on the iLO CM module. To
communicate with the switch remotely, connect the iLO CM management port to the management network.
After connecting the iLO/MGMT port to the management network, perform the following:
•
Configure a static management IP address or use DHCP services to assign a management IP address.
•
Configure access authentication methods.
To see configuration procedures, see the
HP Moonshot-45XGc Switch Fundamentals Configuration Guide
in
the HP Moonshot Switch Library
Accessing the CLI using iLO
To connect to the switch VSP from the iLO CLI, enter:
connect switch vsp {sa|sb}
The switch console is displayed.
Interacting with the switch from the iLO CM firmware
Interact with the switch using the following iLO CM firmware commands.
To show switch information:
o
show switch info
o
show switch list
o
show switch sn {sa|sb|sa-b}
o
show switch pid {sa|sb|sa-b}
o
show firmware revisions