HP Model 745 - VME Workstation, Owner'S Manual, Page: 108 / 220

7-8
Installing and Configuring Mass Storage Devices
Installing Mass Storage Devices
Installing a Device in a Mass Storage Carrier
1 Remove the new device from its shipping box
2 Ensure that the hardware SCSI bus address selected on the device is not
already used by the system.
3 In the case of a removable media device (flexible disk, CD-ROM, or DDS
tape) note any special requirements for bezel installation.
4 Decide where to mount the device, and remove the appropriate disk carri-
er from the system (to install a disk in the fixed disk bay, you must remove
the front disk carrier).
5 If this is a removable media device, remove the appropriate filler panel(s)
from the disk carrier.
NOTE: Hard disk drives require special rubber grommets and mounting screws,
shipped with the system.
6 If this is a hard disk drive, place the four rubber grommets in the mounting
holes, as shown in Figure 7-4.
7 Place the device in the carrier and align the screw holes. See Figure 7-3
though Figure 7-6.
Adapter brackets are shipped with the system to allow mounting a 3.5-
inch device in the upper (5.25-inch) slots of the disk carriers. If these
brackets are installed into the disk carriers, you do not need to remove
them to install the device. The brackets are packaged seperately if a 5.25-
inch device is mounted in this slot.
8 Start, but do not tighten, each mounting screw.