
9
BMC SETUP
Quick setup
To quickly setup BMC using the default settings for BMC features, follow the steps below:
1.
Prepare the hardware installation — Refer to the MicroServer Remote Access Card Installation
Instructions for detail
2.
If you are not using dynamic IP addressing, use the BIOS RBSU to configure a static IP address
(“Configuring the IP address”).
3.
Methods for Log in: Users can either:
-
Log into BMC from a supported browser (“Logging in to BMC Web for the first time”).
or
-
Log into SMCLP via a SSH client. (“Logging in to BMC SMCLP for the first time”)
Preparing to setup BMC
Before setting up your BMC, you must install Remote Access Card and remove VGA cable from
embedded VGA connector to VGA connector on the Remote Access Card. Since the server will export
VGA signal via the VGA connector on this card automatically when the Remote Access Card is
plugged (BIOS default setting).
To reinstall the Remote Access Card
1.
Open the chassis and remove the system tray out of the chassis.
2.
Lift the Remote Access Card to release it from the connector (1).
3.
Put the card into an anti-statistic bag.
Summary of Contents for MicroServe
