Troubleshooting & FAQs
143
8.
Click
Next
on the
Rebooting your server into recovery mode
dialog box and
follow the instructions on each dialog box.
During Server Recovery, the following may happen:
•
If the recovery program cannot find the server, see
No Server Found
.
•
If the Server Recovery cannot recover the partition data, the progress bar
will go to 100% and then back to zero and start over.
•
If the recovery fails, see
Server Recovery Fails
.
9.
The server restarts after the Server Recovery or Factory Reset completes. Wait
until the Health indicator is solid aqua white
before proceeding to the next
step.
10.
Click
Finish
on the
Server recovery complete
dialog box.
The HP MediaSmart Server software is automatically installed on the computer
where you performed the Server Recovery or Factory Reset.
11.
Run the Software Installation Disc on each additional network computer. For
additional information, see
Installing the Software on Additional Home
Computers
.
Caution
If you did not close the HP MediaSmart Server Control Center, as indicated in
step 1, you may see a message asking you to reboot your computer. If you see this
message, choose to reboot later. Otherwise, rebooting may leave the server in a
state where it cannot be configured, and you will have to repeat the recovery or
reset process.
Summary of Contents for LX195 - MediaSmart Server - 1 GB RAM
