HP J9146A - ProCurve Switch 2910al-24G-PoE, Installation And Getting Started Manual

Page: 60 / 116

3-2
Getting Started With Switch Configuration
Using the Console Setup Screen
Ge
ttin
g
Sta
rt
e
d
Wit
h
S
w
itc
h
Co
nf
igur
at
io
n
N o t e
By default, the switch is configured to acquire an IP address configuration
from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual
method described in this chapter, see “DHCP/Bootp Operation” in the
Management and Configuration Guide, which is on the ProCurve Website at
www.hp.com/go/procurve/manuals
.
Using the Console Setup Screen
The quickest and easiest way to minimally configure the switch for manage-
ment and password protection in your network is to use a direct console
connection to the switch, start a console session, and access the Switch Setup
screen.
1. Using the method described in the preceding section, connect a terminal
device to the switch and display the switch console command (CLI)
prompt (the default display).
The CLI prompt appears displaying the switch model number:
ProCurve Switch 2910al-48G#
2. At the prompt, enter the
setup
command to display the Switch Setup
screen. The following illustration shows the Setup screen with the default
settings.
3. Use the
[Tab]
key to select the Manager Password field and enter a manager
password of up to 16 characters.
2910al-48G
2910al-48G
5
8