ProCurve Networking by HP
Prod. J8999A
ASSEMBLY
Install the articulating mount to the antenna back plane, as
shown in Figure-1:
1. Find the molded antenna mount (3) and four 8-32 nylon lock nuts (4).
Use the nuts to attach the mount to the exposed studs on the back of
the antenna.
2. Find the molded articulating arm (2). Also, find a 1/4"-20 x 1-1/4"
machine screw (5), 1/4" lock washer (6), 1/4" flat washer (7), and 1/
4"-20 hex nut (8). Use hardware to secure the molded arm to the
antenna mount as shown in Figure-1.
3. For installation on flat surfaces, find the molded wall/mast mount (1)
and use it as a drill template to mark hole locations. Drill four 3/16"
diameter pilot holes and install wall anchors (9). Install the mount
using four 8-18 x 3/4" self-tapping screws (10).
4. For pole or mast installations, find two worm clamps (11) and install
as shown on the molded wall-mast mount (1). Encircle pole with each
band and tighten.
5. To attach the antenna assembly to the wall/mast mount, find a 1/4" x
1-1/4" machine screw (5) and install a 1/4" lock washer (6) and a 1/
4"- flat washer (7) as shown. Use the screw to attach the free end of
the articulating arm to the mount, securing in place with a 1/4"-20
nut (8).
6. Loosen 1/4"pivot screws as needed to position antenna for desired
azimuth and elevation steering. When antenna is in adjusted, tighten
all hardware securely.
Hardware for MountingAntenna J8999A
Summary of Contents for J8999A
Page 3: ...ProCurve Networking by HP Prod J8999A J8999A Radiation Plots E Plane 2 4 2 5 GHz Band ...
Page 4: ...ProCurve Networking by HP Prod J8999A J8999A Radiation Plots H Plane 2 4 2 5 GHz Band ...
Page 5: ...ProCurve Networking by HP Prod J8999A J8999A Radiation Plots E Plane 4 9 5 99 GHz Band ...
