5.
Remove and discard the center screw, allowing the slide
to lower slightly, and then tighten the outer screws.
6.
Place the server on the slides using a lift kit.
WARNING:
The weight of this product requires a lift
to install. Do not manually lift the server to install it.
Use a lift that can handle the load of your server.
CAUTION:
This server must be unpacked in an ESD
safe environment. Observe all ESD safety
precautions before attempting this procedure. Failure
to follow ESD safety precautions can result in
damage to the server.
7.
Insert screws to secure the server to the slides.
8.
Install the cable management arm.
a.
Attach screws
(B)
to the left rear column.
b.
Slip the cable management arm over the screws
(B)
,
and tighten.
c.
Extend the cable management arm to the left rear
side of the product.
d.
Attach the cable management arm to the studs, and
secure it with nuts
(E).
Summary of Contents for J1530C
Page 5: ......
