Service access cover latch
NOTE:
The service access cover latch is included with the base enclosure assembly, spare part
number 652649-001.
Before removing the service access cover latch, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 48
).
5.
Remove the service access cover (see
Service access cover on page 50
).
6.
Remove the following components:
a.
Hard drive (see
Hard drive on page 60
)
b.
Optical drive (see
Optical drive on page 65
)
c.
Keyboard (see
Keyboard on page 67
)
d.
Top cover (see
Top cover on page 71
)
e.
Video card fan/heat sink assembly (see
Video card fan/heat sink assembly on page 84
)
f.
Processor heat sink (see
Processor heat sink on page 86
)
g.
System board (see
System board on page 107
)
h.
RJ-11 connector cable (see
RJ-11 connector cable on page 113
)
Remove the service access cover latch:
1.
Position the computer right-side up with the front toward you.
2.
Remove the three Phillips M2.0×2.0 screws
(1)
that secure the service access cover latch to the
base enclosure.
Component replacement procedures 115
Downloaded from LpManual.com Manuals
