h.
Heat sink (see
Heat sink on page 76
)
i.
Modem module (see
Modem module on page 92
)
j.
System board (see
System board on page 97
)
Remove the RJ-11 connector cable:
1.
Position the computer right-side up, with the front toward you.
2.
Remove the RJ-11 connector
(1)
from the clip built into the base enclosure.
3.
Remove the RJ-11 connector cable from the clips and routing channel
(2)
built into the base
enclosure.
4.
Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.
100 Chapter 4 Removal and replacement procedures
