HP E2466C, User Manual

Page: 18 / 93

To connect to the target system
The probe end of the preprocessor connects directly to the microprocessor
on the target system.
1
To prevent equipment damage, remove power from both the logic
analyzer and the target system.
C A U T I O N
Serious damage to the target system or preprocessor interface can result
from incorrect connection. Note the position of pin A1 on the preprocessor
interposer and on the microprocessor before making any connection. Take
care to align the preprocessor connector assembly with the pins on the
microprocessor so that all pins make contact.
2
Install the interposer onto the microprocessor on the target system.
The alignment tabs on the interposer aid in making proper alignment.
Ensure that pin A1 is oriented correctly (see figure below).
Probe Connection Overview
Figure 5
Setting Up the Preprocessor Interface Hardware
To connect to the target system
Preprocessor Interface for the Pentium II Processor 1-9