NOTE:
The
Move to printing (custom)
position allows you to set the printhead-to-substrate
distance for thick substrates or substrates that may wrinkle in the print zone, to avoid ink smearing.
Be aware that raising the printhead from the substrate may give poorer print quality.
WARNING!
Do not insert your hands or anything else into the printer while the carriage beam
is descending.
20.
Tell the printer to check the loaded substrate. The printer rotates the rolls to check their diameters,
and it also checks the width of the roll, the winding direction, the vacuum and the substrate
advance calibration (this takes 3–4 min).
NOTE:
Some substrates (such as transparent substrates) cannot be measured by the printer in
this way. In such cases, you will be asked to enter the required information manually. Use the
scale on the curing module to see the value for the right-hand edge that must be entered manually.
21.
In the HP Internal Print Server, choose from the list of substrate types the type that you have
loaded.
The contents of the Loaded Substrate window are determined automatically when the substrate is
loaded and checked. However, if the printer is unable to detect the edges of the substrate (for
instance, in the case of a transparent substrate), you will have to measure the distance of the left
edge from the printer's side plate, and complete the Left Edge and Width fields yourself.
An alert regarding substrate advance tracking may appear at this point. For more information, see
your printer's documentation.
The printer is now ready to print.
ENWW
Load rolls into the printer
9
Dual-r
oll spindle
Summary of Contents for Dual Roll Kit
Page 1: ...SCITEX Dual Roll Kit User s guide ...
Page 4: ...iv ENWW ...
