4.
If you need to raise the carriage beam, go to the front panel and select the Substrate menu
,
then
Substrate management
, and press
OK
. Select
Carriage beam position
>
Move to
highest position
. This process takes about 2 minutes to complete.
The printer raises the carriage beam, making it easy to insert the substrate. This process takes
about 2 minutes to complete. During this period, you can load the input and output rolls.
NOTE:
While the carriage beam is rising, you can stop it by pressing the
Cancel
key.
5.
You may find it helpful to lock the differentials on the input and output spindles while loading.
6.
Bring the new rolls on their spindle to the rear of the printer, with the geared end of the spindle on
the left.
7.
If the two rolls are of unequal lengths, the longer roll should be on the right as seen from the front
of the printer; on the left as seen from the rear.
NOTE:
When the shorter roll comes to an end, you should lock the differential hub if you intend
to continue printing on the longer roll.
8.
Rest the ends of the spindle on the platforms provided at the rear of the printer; plastic pads are
provided to absorb the impacts.
6
Chapter 2 Use of the dual-roll spindle
ENWW
Dual-r
oll spindle
Summary of Contents for Dual Roll Kit
Page 1: ...SCITEX Dual Roll Kit User s guide ...
Page 4: ...iv ENWW ...