Installing Hardware Options
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
2-7
HP CONFIDENTIAL
Writer: Richard O. Heath File Name: c-ch2 Installing Hardware Options.doc
Codename: Ertl Part Number: 293974-001 Last Saved On: 10/16/02 1:34 PM
Table 2-1: System Board Connectors and Components
Item Description
Item Description
1
PCI riser board slot 1 connector
10
Power signal connector
2 Battery
11 System
power
connector
3
DIMM slots (four)
12
PPM socket 2
4
Processor Power Module (PPM)
socket 1 (shown with PPM installed)
13
Smart Array 5i memory connector
5
Processor 1 socket (shown with
processor/heatsink installed)
14
Debug LED switch bank (SW3)
6
Processor 2 socket
15
Redundant Power Supply/PCI install
switch bank (SW1)
7
Fan board connector
16
PCI riser board slot 2 connector
8
SCSI board connector
17
System maintenance switch (SW2)
9
Optical device/floppy board signal
connector
Installing Additional Memory
Server memory can be expanded by installing Double Data Rate Synchronous
DRAM (DDR SDRAM). The system supports up to four PC2100 ECC registered
DDR SDRAM Dual Inline Memory Modules (DIMMs) installed in four sockets on
the system board. Memory must be added two equivalent modules at a time.
Refer to Figure 2-4 and to Table 2-1 for DIMM slot location and socket numbers.
This information is also available on the hood label. Memory must be installed in the
lowest DIMM socket number to the highest.
The following guidelines must be observed when installing additional memory:
•
DIMMs installed in the server must be PC2100 registered DDR SDRAM, 3.3 V,
64 bits wide, and ECC.
