Chapter 6
HP NetRAID Software
73
Step K. Install NOS-specific Configuration Utility
In this step, you install the configuration utility specific to your NOS.
•
If you are using any version of Microsoft Windows NT or Windows 2000,
you install the HP NetRAID Assistant utility. This is the Windows NT
and Windows 2000 version of the utility you used to configure your
system in Chapter 5, "Installation and Configuration."
•
If you are using Novell NetWare, SCO UnixWare, or SCO OpenServer,
you install the HP NetRAID Config utility.
Chapter 10, "Understanding HP NetRAID Utilities," has menu maps of both of
these utilities. For complete information about these utilities, see the HP
NetRAID Series User Guide in Information Assistant on the HP Netserver
Navigator CD-ROM.
Install the utility as described for the NOS version below.
Microsoft Windows NT 4.0 and Windows 2000
1. Select Start from the taskbar.
2. Choose Run from the Start menu.
3. Insert diskette #1, "NetRAID Software—NT/Win2000."
4. Type
<d>:\setup
at the Open: prompt, where
<d>
is the drive letter of
the diskette drive you are using.
5. Follow the on-screen instructions.
NOTE
Setup installs the following HP NetRAID-1M or 2M software:
•
HP NetRAID Assistant (nraid.exe)
•
HP NetRAID Monitor Service (megaserv.exe)
•
HP NetRAID Consistency Check Scheduler
(megactrl.exe)
