Chapter 1
Introduction
9
•
Technical Reference Cards or labels on the HP Netserver system chassis
(for cables and SCSI ID switch settings)
•
Internet site:
http://netserver.hp.com/netserver/
Tools You May Need
Please refer to your HP Netserver documentation for the tools needed to open the
chassis. Usually a flat 1/4-inch screwdriver and a T15 Torx driver are required. If
you need to set SCSI ID switches, a flashlight and a small metal pin, such as a
straightened paper clip, will be helpful. An antistatic kit (3M 8501/8502/8505 or
equivalent) is strongly recommended.
CAUTION
All HP NetRAID adapter cards are sensitive to static
electricity and can easily be damaged by improper handling.
Using a grounding strap is recommended. Read the following
information carefully before you handle the accessory:
•
Leave the adapter card in the antistatic bag until you are
ready to install it.
•
If possible, use an antistatic wrist strap and grounding
mat.
•
Before you remove the adapter board from the bag, touch a
grounded, unpainted metal surface on the system to
discharge static electricity.
