HP Array Configuration Utility 57
Keyword
Abbreviation in ACU
CLI
Keyword
Abbreviation in
ACU CLI
licensekey
lk
tapedrive
td
logicaldrive
ld
waitforcacheroom
wfcr
mnpdelay
mnpd
—
—
*The CLI also uses this keyword and abbreviation for the terms
box name
and
RAID array ID
.
The show command
The
show
command enables you to obtain information about a device.
Syntax:
<target> show [detail]|[status]
When you specify a target that consists of several devices, the information in the output is normally less
comprehensive than when you specify only one device as the target. You can use the
[detail]
parameter
in this case to retain all the information usually given for individual devices.
An extra parameter is available for controller targets:
config
. This parameter is used as follows:
<target controller> show config [detail]
If you use the
config
parameter, the output includes information about each device connected to the
controller.
Example 1
=> ctrl slot=9 show
A typical output would be:
Smart Array P421 in Slot 9
Bus Interface: PCI
Slot: 9
Serial Number: PBKTV0XTAZZ005
RAID 6 (ADG) Status: Enabled
Controller Status: OK
Hardware Revision: A
Firmware Version: 0.02-106
Rebuild Priority: Medium
Expand Priority: Medium
Surface Scan Delay: 3 secs
Surface Scan Mode: Idle
Queue Depth: Automatic
Monitor and Performance Delay: 60 min
Elevator Sort: Enabled
Degraded Performance Optimization: Disabled
Inconsistency Repair Policy: Disabled
Wait for Cache Room: Disabled
Surface Analysis Inconsistency Notification: Disabled
Post Prompt Timeout: 15 secs
Cache Board Present: True
Cache Status: OK
