HP B1476 68020, User Manual, Page: 70 / 724

To step through the program
You can execute one source line (high-level mode) or one instruction
(assembly-level mode) at a time by stepping through the program.
•
Using the command line, enter:
Program Step
You can step again by just pressing
<Return>
.
As the debugger steps through the program, you can see the PC progress
through the source code, as shown by the inverse video line in the Code
window.
To step over functions
You can either step through functions or step over functions. When you step
over a function, it is executed as a single program step.
•
Using the command line, enter:
Program Step Over
To delete a breakpoint
Once you set a breakpoint, program execution will break each time the
breakpoint is encountered. If you don’t want to break on a certain breakpoint
again, you must delete the breakpoint. Suppose you want to delete the
breakpoint that was previously set at the statement "update_system()".
1 R un the program up to the breakpoint:
Chapter 2: Getting Started with the Standard Interface
To step through the program
46