HP 70908A, Service Manual

Page: 53 / 335

Reading errors from ERRORLOG failed. Check disk at ____.
The program tried to read error data from the Operating Disk. Check that the Operating
Disk is installed in the drive specied in the error message .
Return to Equipment Menu to enter serial number for ____.
Y ou must return to the Equipment Menu edit screen and enter a SERIAL or ID NO . for the
passive device selected before you can edit the device's calibration data.
Setup Error
The program aborted the test after attempting to verify the test setup . Ensure that all
required ETE is present, has been turned on, and is properly connected.
SORRY, but your SERIAL NUMBER must end in a NUMERIC -- This is ____.
Contact Hewlett-P ackard Santa R osa Systems Division for assistance .
Test can not be done.
Required ETE is missing. Return to the Equipment Menu and enter all ETE listed as
required for the current test.
TEST_LIST is not compatible.
A bad test list exists . Contact Hewlett-P ackard Santa R osa Systems Division for assistance .
The controller does not have sufficient memory. This software cannot load. See the
computer hardware system documentation for information on adding additional memory.
Either refer to the appropriate manual to extend the memory capability of your system, or
o-load some data to make room for the program.
The ____ at address ____ was not found on HP-IB.
When V erify HP-IB is set to ON in the P arameter Menu, this error message displays the ETE
with the address that is either missing or not set to ON.
The 436A is in lowest range, waiting 10 seconds.
The current power measurement requires the lowest power-meter range . Program
execution will resume in 10 seconds .
The 8902A needs repair (Error 6).
There is a problem related to the HP 8902A measuring receiver . Correct the fault or return
to the Equipment Menu where you can enter a dierent model number .
The DUT must have an HP-IB address.
Y ou attempted to leave the Equipment Menu, but the program cannot nd the
HP 70000 system at the assigned HP-IB address .
THIS COLUMN CAN NOT BE EDITED.
Y ou pressed
NNNNNNNNNNNNNNNNNNNN
SELECT with the cursor positioned in the rst column of the Mass Storage edit
screen or the Equipment Menu edit screen. This column cannot be edited.
THIS IS ____ AND FOUND DUPLICATE FILES: ____.
Contact Hewlett-P ackard Santa R osa Systems Division for assistance .
This test can not be selected because of missing ETE.
Y ou were in either Multiple T ests or Repeat Multiple , then tried to select a test that has
missing ETE. This is not allowed. Check the Status column of the T est Menu to verify a
Missing ETE tag next to the test name you attempted to select.
2-28 Module V erication Software