Optical drive
Description
Spare part number
DVD-ROM Drive (includes bezel and bracket)
481094-001
Before removing the optical drive, follow these steps:
1.
Shut down the computer.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Battery on page 30
).
Remove the optical drive:
1.
Remove the memory module compartment cover (see
Memory module on page 32
).
2.
Position the computer with the right side toward you.
3.
Remove the Mylar screw cover
(1)
that secures the optical drive retention screw. The Mylar screw
cover is available in the Rubber Kit, spare part number 481106-001.
4.
Remove the two Torx T8M2.0×5.0 screws
(2)
that secure the optical drive to the computer.
5.
Insert a thin tool, such as a paper clip
(3)
, into the release access. (The optical drive disc tray is
partially ejected from the optical drive.)
6.
Remove the optical drive
(4)
from the computer.
7.
If it is necessary to replace the optical drive bracket, position the optical drive with the rear toward
you.
8.
Remove the two Phillips PM2.0×4.0 screws
(1)
that secure the optical drive bracket to the optical
drive.
38
Chapter 4 Removal and replacement procedures
Summary of Contents for 2533t - Compaq Mobile Thin Client
Page 1: ...HP 2533t Mobile Thin Client Maintenance and Service Guide ...
Page 4: ...iv Safety warning notice ...
Page 8: ...viii ...
Page 116: ......
