NOTE:
When replacing the system board, be sure that the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory module (see
Memory module on page 76
)
●
Heat sink assembly (see
Heat sink assembly on page 72
)
To remove the system board:
1.
Position the computer upright, and then disconnect the following cables from the system board:
(1)
: Power connector cable
(2)
: Speaker cable
(3)
: Fan cable
(4)
: Display cable
2.
Remove the two Phillips PM2.5×5.0 screws
(5)
that secure the system board to the computer.
68
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Summary of Contents for 15 Notebook PC
