HP 12500 Series, Installation Manual, Page: 112 / 152

106
Table 39 OAA card specifications
Model Interfaces
Supported interface
modules
LST1FW2A1
•
One console port
•
One CF card slot, supporting a 256M, 512M, or 1G CF
card
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
GE SFP modules
LST1FW3A1
•
One console port
•
One CF card slot, supporting a 256M CF card
•
Two USB ports (reserved for hardware, not supporting
software)
•
Two GE combo interfaces
GE SFP modules
Power components
Select AC or DC power components according to the power supply mode of your switch.
•
Choose power supplies based on your actual needs. Make sure the maximum output power of the
power supplies exceeds the system power consumption (HP recommends reserving a certain power
de-rating value). For the maximum output power of a single power supply, see
Table 41 .
•
HP recommends you to configure N+1 or N+M power supply redundancy.
•
To use AC power supply, select the specific 16 A AC power cords. For the 16A AC power cords
used in different countries or regions, see
Table 42 .
Table 40 Power system ordering guide
Model
Power
supply
mode
Power components Configured quantity
PSE9000-A1 AC
AC power frame
•
1 for the 12504 or 12508
•
2 for the 12518
PEM One is required for each power frame
Power monitor module One is required for each power frame
AC power supply
•
6 at most for the 12504 or 12508
•
12 at most for the 12518
PSE9000-D DC
DC power frame
•
1 for the 12504 or 12508
•
2 for the 12518
Power monitor module One is required for each power frame
DC power supply
•
6 at most for the 12504 or 12508
•
12 at most for the 12518