HP 12200, User Manual

Page: 136 / 205

Output Commands
Use the CLI commands in CLI output commands to control the output and display help information
for the CLI commands.
Table 15 CLI Output Commands
Description Command
Displays the stack trace after an exception has occurred.
trace
Toggles verbose output on and off. When on, all messages are output to the screen.
verbose
Indicates current CLI version. If verbose is on, the module revisions display also.
version
Displays CLI command usage information. Where
<-tag>
can be:
-c<command>
- Provides help information for the specified CLI command.
help
-all
- Lists all CLI commands and their help information.
Enables VLS logging. Where the options are:
-d<n>
- Debug level (1 to 9) (optional)
enableVlsLog
-h
- Displays command usage information (optional)
Disables VLS logging. Where the options are:
-d<n>
- Debug level (1 to 1) (optional)
disableVlsLog
-h
- Displays command usage information (optional)
VLS Commands
This section describes the VLS commands in the VLS CLI command set.
Network Settings Configuration Commands
Use the CLI commands in CLI network settings configuration commands to configure the VLS network
settings via a serial session. See “Opening a Serial Session” (page 82) .
Changing the network configuration parameters modifies four system files:
/etc/hosts
/etc/sysconfig/network
/etc/resolv.conf
/etc/sysconfig/network-scrips/ifcfg-eth1
Table 16 CLI Network Settings Configuration Commands
Description Command
Lists host name, DNS domain name, DNS address, and various other addresses. This
command shows both the current internal values, as well as the original values. It also
lists the current and new content of all files affected by the changes.
showConfig
Sets the value of the corresponding configuration parameter. To reset a value, enter “ “
(quoted space) as the value. More than one tag and value can be set at a time. Where
<-tag>
can be:
-host
- Host name (such as vlsexamp) (unqualified)
setConfigValue
<-tag> [value]
-domain
- DNS domain name (such as xyz.com)
-fullhost
- Fully qualified name (such as vlsexamp.xyz.com)
—ntpPrimary
- First NTP Server Address
—ntpSecondary
- Second NTP Server Address
-dnsaddr
- DNS server address (replaces all addresses with one line)
-dnsaddr1
- First DNS server address (cannot use with dnsaddr)
136 CLI Command Set