HP 10:10 LAN Bridge MB, Installation And Reference Manual

Page: 29 / 122

Configuration Commands
ADdress Table
Enter
AD
at the Config prompt to start the address table command. You are prompted to add,
delete, or read address table entries. The ADd and DElete commands affect only the static
address table entries. Enter
HE
at the add, delete, or read prompts to get help on completing
these tasks.
Default Configuration: no static entries in the address table.
For more information about address table function, see chapter 6, “How the Bridge Works”.
IP config
Enter
IP
at the Config prompt to start the IP config command. Use this command if you wish
the bridge to be accessible using IP (the Internet Protocol). If either of the following is true,
you must set the IP configuration parameters on the bridge:
The bridge will be managed remotely with a network management product, such as HP
OpenView Interconnect Manager, over a TCP/IP network (a network operating system
that uses IP communications).
The network cable segments attached to the bridge will be tested using the IP “Ping”
test.
Default Configuration: IP address is
0.0.0.0
which disables IP communications on the
bridge.
IP config information is continued on the next page.
Configuration 3-5