Gear system and chain
51
Handling instructions
worn sprocket or chain ring. We recommend
rust resistant Rustbuster-chains from KMC
with smoothly rounded edges. They also pro-
vide a good gear changing performance.
Attention!
When you change
the chain take care that the new chain
does not show any sharp edges or burrs.
HP V
ELOTECHNIK
delivers spare chains by the
meter via your dealer. For this purpose please
indicate the exact length of your chain or or-
der it a little bit longer if you want to be sure
it fits. You will need approximately 3,8 m of
chain.
The chain length has to be fitted so that the
arm of the derailleur is not fully stretched
when you shift on the big chain ring in front
and the big rear sprocket. The derailleur must
still be able to compensate a shortening of the
chain by 4 cm. Please also see the manual of
the derailleur manufacturer on the choice of
the correct chain length.
Attention!
The chain has to be
closed with a special joining link or a chain
riveting tool that expands the ends of the
rivet while riveting (R
OHLOFF
revolver). A
poorly joined chain may break, you can
come off the pedals and fall. If you are in
doubt please have adjustments of the chain
length or the changing of the chain be done
by your bicycle mechanic.
Take care that the joining link is not bigger in
size than the other chain links to avoid irregu-
lar chain sounds. We recommend the joining
links by KMC. Every time you change the
chain you also have to apply a new joining link.
Make sure that any chain links in the chain are
not stiff, as this can cause some annoying and
not obvious problems with the gear system.
Make sure that you have not twisted the chain
180 degrees before joining it back together.
Chain tubes
The chain protection tubes are made of a long
lasting plastic that features very low friction,
slow wear and good noise damping. The tubes
protect your clothes against the chain oil as
well as the chain against dirt from the road.
The upper tubes are fastened with an inter-
changeable retention spring, the lower tube
runs through an adjustable clip.
The tubes are worn by the chain and have to
be cut at the ends and expanded again (or ex-
changed) after 3.000 – 5.000 km approxi-
mately, depending on the chain type and the
overall riding condition. You can extend this
maintenance interval by turning the tubes by a
quarter turn from time to time so that they
do not keep wearing out in the same place.
The intensity of the wear depends mainly on
the chain type. Please see also the instructions
on "Chain" on page 51. In order to perform
any work at the chain tubes you'll have to
open the chain and finally close it again. Please
see the instructions on "Chain" on page 38.
The distance of the upper chain tube to the
chain wheel can be adjusted by sliding the
tube in the retention spring. It must be se-
cured with the rubber tube over the spring.
