8.
To replace the component, reverse the removal procedure.
9.
Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.
Removing and replacing the system board
Procedure
Removing the system board
1.
Power down the server (
on page 36).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (
Remove the server from the rack
on page 37).
4.
Remove all power supplies (
Removing and replacing the AC power supply
on page 43).
5.
on page 39).
6.
Do one of the following:
• Remove the air baffle (
on page 44).
• Remove the 4 LFF midplane cage (
Removing and replacing a 4 LFF midplane cage
on page 63).
7.
Remove the primary or secondary PCIe riser cage (
Removing and replacing the primary or
on page 45).
8.
If installed, remove the tertiary PCIe riser cage (
Removing and replacing the tertiary PCIe riser cage
on page 46).
9.
Remove the FlexibleLOM (
Removing and replacing the FlexibleLOM
on page 53).
10.
on page 73).
11.
Removing and replacing the fan cage
on page 52).
12.
Disconnect all cables connected to the system board.
13.
Observe the following cautions.
CAUTION:
Be sure to loosen each screw in the order indicated. Otherwise, damage might occur to the
heatsink or processor.
Removing and replacing the system board
77
Summary of Contents for ProLiant DL380
