25
4 214 864 / 02
InSTAllATIOn
4.7
Electrical connection
A qualified technician must install the electri
-
cal supply to the equipment.
The connection diagram is located in the elec-
trical box of the heat generator; the circuit dia-
gram is supplied separately.
WARNING
The heat generator can only be de-energised
by disconnection from the mains (e.g. all-
pole switch).
WARNING
All electric power supply circuits must be
switched off before accessing the terminals.
Cables to be connected may be lead laterally along the
boiler into a cable channel forward towards the control
box. A removable, narrow covering is located on the con-
trol box. The cables may be lead through the cover open-
ing into the control box.
Important!
A main switch must be installed on-site in the supply line
which performs an all-poles cut-out and has a clearance
of at least 3 mm between the open contacts.
For Switzerland:
The plant specific electrical plan must be followed when
making the electrical connection, if one is available!
Open electrical box fully:
Remove wing nut and loosen holding cord
Cable feed-in is at the bottom
Folding out the electrical box
(Opening angle 55°):
Remove the screws (left and right)
Summary of Contents for CompactGas
Page 36: ...36 4 214 864 02 ...
Page 37: ...37 4 214 864 02 ...
