23800-5-0909
Page 17
PIEZO PILOT IGNITOR
Piezo Pilot Ignitor Instructions
Piezo is located adjacent to gas valve. Open casing door to access
piezo ignitor.
Depressing the piezo ignitor button completely causes a spark to
occur at the pilot. This is a substitute for a match which requires
opening the pilot hole cover.
To light the pilot, it is important that the electrode be 1/8” (3 mm)
from the thermopile. The spark must occur at the point the burner
flame hits the thermopile. The end of the electrode will be red hot
with the pilot on.
On a new installation with air in the gas line, it is suggested that a
match be used. The match will light the pilot faster than the piezo
under this condition.
PIEZO IGNITOR
OPTIONAL THERMOSTAT BRACKET INSTALLATION
4. Attach the thermostat bracket to the outer casing with two (2)
8 x 3/8" Phillips screws.
Figure 34
5. Replace the outer casing.
6. Remove cover of thermostat from base.
Figure 35
7. Feed wires through rectangular slots.
Figure 36
8. Attach thermostat to bracket with two (2) 8 x 3/8" Phillips
screws.
Figure 37
9. Connect the thermostat wires to the terminal screws.
Figure 38
10. Replace thermostat cover.
Figure 39
