Hotsy EP • 8.914-444.0 • Rev. 07/13
7
PRESSURE W
ASHER
OPERA
T
OR’S MANU
AL
STEP 1:
Attach the handle to the
frame of the pressure washer.
Note
: It may be necessary to move
the handle supports from side to
side in order to align the handle
so it will slide over the frame sup-
ports.
STEP 2:
Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
STEP 3:
Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STEP 4:
Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
STEP 7:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 8:
Connect the high pres-
sure hose to the pumps discharge
nipple. Push coupler collar forward
until secure.
STEP 5:
Attach nozzle extension
to spray gun/wand. Tighten both
by hand.
STEP 6:
Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
STEP 9:
Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 10:
Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump without
water or pump damage will result.
Alignment
Holes
Handle
Frame
Assy.
Carriage
Bolt
Nut
Studs
Nut
Hose/Gun
Storage
Bracket
Safety
Latch
Spray
Gun
High Pressure
Hose
Nozzle Extension
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden Hose
Coupler Collar
Bolts
