Hotpoint BWM 129, Instructions For Installation And Use Manual

Page: 8 / 20

$
GB
Instructions for the fitter
Mounting the wooden panel onto the door and
inserting the machine into cabinets:
In the case where the machine must be shipped for
final installation after the wooden panel has been
mounted, we suggest leaving it in its original
packaging. The packaging was designed to make it
possible to mount the wooden panel onto the machine
without removing it completely
(see figures below).
The wooden panel that covers the face of the machine
must not be less than
18 mm in thickness and can be
hinged on either the right or left. For the sake of
practicality when using the machine, we recommend
that the panel be hinged on the same side as the door
for the machine itself - the left.
A
B
C
D
E
Tur seite
Door Mounting Accessories (Fig. 1-2-3-4-5).
Fig. 1
N° 2 Hinges
N° 1 Magnet N° 1 Magnet plate
N° 1 Rubber plug
N° 2 Hinge Supports
N° 1 Spacer
Fig. 2
Fig. 3 Fig. 4
Fig. 5 Fig. 4/B
- No. 6 type A self-threading screws, l =13 mm.
- No. 2 type B metric, countersunk screws, l =25; for
fastening the magnet plate to the cabinet.
- No. 4 type
C metric screws, l =15 mm; for mounting
the hinge supports to the cabinet.
- No. 4 type
D metric screws, l =7 mm; for mounting the
hinges on the supports.
Mounting the Parts onto the Face of the Machine.
- Mount the hinge supports onto the face of the
machine, positioning the hole indicated by the arrow in
fig. 1 towards the inside of the face and using the type
C screws.
- Mount the magnetic plate on the opposite side, at
the top, using the two type
B screws.
- Place the spacer illustrated in fig. 4/B between the
appliance front and the magnet receiver.