GB
5
5. Unscrew the oven burner
nozzle using the special
socket spanner for the
nozzles, or better still a 7 mm
socket spanner, and replace it
with a nozzle suited to the
new type of gas
(see Table 1)
.
6. Replace all the parts, following the steps
described above in the reverse order.
T
ake
particu
l
ar
care
w
hen
hand
l
ing
the
spark
p
l
ug
w
ires
and
the
thermocoup
l
e
pipes
.
Primary air regulation for the oven burner
The burner was designed not to need any
adjustments to the primary air.
Setting the oven burner to minimum
1. Turn the knob first to the Max setting for about 10
minutes and then to Min.
2. Remove the knob.
3. Remove the disk fastened to the control panel.
4. Adjust the screw located outside the thermostat
cock pin until the flame is small but steady (the
flame can be seen through the slots on the oven
bottom).
5. Make sure the
burner does not switch
off when you turn the
knob from Max to Min
quickly, or when you
open and close the
oven door quickly.
DATA PLA TE
D imensions
width
43.5
cm
height
31
cm
depth
43.5
cm
Volume
58
l
Electrical
connections
see
data
plate
Gas features
see
data
plate
This
appliance
conforms
to
the
following
European
Economic
Community
directives:
2006/
9
5/EEC
dated
12/12/06
(Low
Voltage)
and
subsequent
amendments
-
8
9
/336/EEC
dated
03/05/8
9
(Electromagnetic
compatibility)
and
subsequent
amendments
-
9
3/68/EEC
dated
22/07/
9
3
and
subsequent
amendments.
9
0/336/EEC
dated
2
9
.06.
9
0
(Gas)
and
subsequent
amendments.
2002/
9
6/EC
If the appliance is connected to liquid gas, the
regulation screw must be fastened as tightly as
possible.
Once this procedure is finished, replace the old
rating sticker with one indicating the new type of gas
used. This sticker is available from any of our
Service Centres.
If the gas pressure is different from the
recommended pressure, a suitable pressure
regulator must be fitted to the inlet pipe in
accordance with current National Regulations.
