15
L
Door
1.
Open the door and remove the 4 screws securing the door assembly to the front panel.
2.
Remove the complete door from the front panel.
3.
Remove 1 screw securing the door latch to the door.
4.
Remove the screw behind the door latch, securing the door handle to the door.
5.
Remove the 6 screws securing the two halves of the door assembly.
6.
The door trims can now be split giving access to the door bowl, handle and door hinges.
M
Door Hinges
1.
The door must be removed and split as in (L1) - (6) above.
2.
Turn the door hinges inwards and slide the hinge upwards
to disengage from the rear trim moulding as in Fig 1.
N
Front Bearings
1.
Remove the front panel as in (G).
2.
Spring the fixing lug out of the open slot in the
bearing mounting bracket and slide the pad along
the bracket to free the other lug as illustrated.
O
Drive Belt Removal - if not broken
1.
Remove the right hand side panel as in (F).
2.
Place the Special Tool, Part Number 5600178, onto the motor shaft as far as possible (cut out
section to base of dryer).
3.
Rotate the tool and remove the belt from the shaft.
4.
Remove the front panel as in (G) and slide the belt off the drum.
Drive Belt Fitting
1.
Slide the new belt onto the drum and replace the front panel.
2.
Place the Special Tool , Part Number 5600266, onto the inside edge of the new belt (cut out
section of tool facing the drum).
3.
Ease the special tool onto the motor shaft as far as possible.
4.
Rotate the special tool in either direction to refit the belt onto the shaft.
P
Capacitor
1.
Remove the right hand side panel as in (F).
2.
Note the wiring connections and disconnect the leads from the capacitor terminals.
3.
Carefully lay the dryer on its back and remove the capacitor securing nut.
Fig. 1
Bearing Pad
Mounting Bracket
